Bathroom Renovation Plumbing Noble Park

Original bathrooms, ready for a change

Plenty of Noble Park houses still have the bathroom they were built with: small, tiled in pastel or mint green, with a bath under the window and galvanised pipe in the walls. A renovation is the best chance to replace that old pipe, bring wastes and venting up to standard and add isolation valves, all while the walls are open.

Planning

Before demolition, we work out where the pipes and drains run now, where you want everything to go and what is practical. Moving a toilet or shower can mean cutting into a slab or running new drains under the floor, which affects cost and time. We tell you upfront.

Rough-in

Once the room is stripped, we run new hot and cold water pipe, waste pipes and vents to the new positions with correct falls. Everything is pressure tested before walls are lined.

Waterproofing

A licensed waterproofer usually applies the membrane. We coordinate so floor wastes, shower drains and puddle flanges sit right and the membrane seals around them.

Fit-off

After tiling we install the vanity, basin, taps, shower, bath, toilet and any accessories, connect and test everything and issue the compliance certificate.

Replace old pipe now

If galvanised or tired copper pipe is in the walls, replace it during the renovation rather than tiling over it. We check it during demolition and quote for replacement so you do not have to open new tiles in a few years.

Accessible bathrooms

Level-entry showers, grab rail backing, higher toilets and lever taps make bathrooms safer for older family members. We plumb accessible layouts and work with occupational therapists.

Townhouse bathrooms

Upstairs bathrooms in townhouses need extra care with wastes and waterproofing, because a leak goes straight into the room below. We test thoroughly before handover.

Laundries and kitchens too

While the plumber is on site, we can also move laundry taps and wastes, connect a dishwasher or relocate a kitchen sink.

Your fixtures

Bought your own tapware or toilet? We install it, after checking it is WaterMark certified and suits your water pressure.

Timing

We give a clear schedule for rough-in and fit-off and turn up on time so your other trades are not waiting.

Planning the layout

Moving a toilet or shower is possible but affects drainage, falls and floor levels. On a concrete slab, moving a waste means cutting the slab. We check what is under the floor before you commit to a layout, so the design and the budget line up.

Working with your builder

We coordinate with tilers, waterproofers and builders on rough-in and fit-off dates.

Fixtures and water use

We help you choose water-efficient tapware and toilets that perform well, and fit them so they are easy to service later.

Compliance

We lodge compliance certificates for the plumbing work, which your builder, insurer and future buyers may ask for. Keep a copy with your renovation paperwork.

Laundry and kitchen too

Many owners renovate the laundry or kitchen at the same time. We rough in and fit off taps, sinks, dishwashers and washing machine connections, and move gas points for new cooktops, so one trade handles all the plumbing in the project.

Noble Park pipes at a glance

Most of Noble Park was built between the late 1940s and the 1970s, so original houses usually have clay sewer pipe, galvanised or early copper water pipe and gas hot water outside the laundry. Newer townhouses on subdivided blocks have PVC drains, plastic or copper water pipe and continuous-flow or heat pump hot water. We use cameras, locators, pressure tests and leak detection gear to see what is going on before anyone digs or cuts a wall.

From your call to the finished job